Custom Tritium Vial holder Steel or Cabon Fiber

[handcannon]

Hi all, I had a few request to do some of the Carbon Fiber Tritium Key Fobs for 3x23 vials with out the vials..

So this is what I have 1-4 are steel key fobs with split rings. Nothing special just a plain old steel. With 4 holes on each side. Easy to install vial. just slip it in the bottom and add epoxy,hot melt, etc. The vial is below the surface so now worries about breaking the vial..
Next up is 5&6 are Carbon Fiber, with split rings installed.These are unidirectional carbon fiber and so they do not have the usual carbon fiber print.. 3 holes on each side.. This one is easy also, do it the same way as above, but you might also have to take out the split ring or slip a needle past the slip ring to even the vial out in the 3 holes, then use your epoxy or hot melt super glue etc.These are done by hand so there will be some slight imperfections..
*************$25.00 ea********** plus $2.00 for shipping.
Payment: paypal(NO FEE), check, Money order.
Please reply in this thread that you want #? so the other CFPM's will know what is still up for grabs...
****************NO TRITIUM VIAL INCLUDED***********
Thanks for looking any questions feel free to ask..Wade
http://www.hunt101.com/data/500/medium/DSC03586.JPG
http://www.hunt101.com/data/500/medium/DSC03583.JPG
http://www.hunt101.com/data/500/medium/DSC03585.JPG

[rocled]

:wave:I love carbon fiber.... do you think we could get a close up pic of the cf fobs?:grin2:

[Cuso]

Is that Stainless???

[handcannon]

Yes I can but this does not have the Carbon Fiber look.. It is a unidirectional carbon fiber not bi-directional..

Nope not stainless...

Wade

[dschumacker@yahoo.com]

any update onthe project u might be down for two of the carbon fiber